Analysis of metal extrusion by the finite volume method
José D. Bressan, Marcelo Matos Martins, Sérgio Tonini Button
ARTIGO
Inglês
Agradecimentos: The authors would like to thank the support of CNPq- Brazil, University of Santa Catarina State (UDESC)-Brazil, University Centre- Catholic of Santa Catarina, Joinville/SC - Brazil and UNICAMP/SP - Brazil
Present work examines and validates the novel numerical scheme to calculate the velocity, stress, strain, pressure and strain rate fields of metal plastic flow in direct extrusion processes by employing the finite volume method, FVM. Traditionally, the classical methods such as the upper-bound,...
Ver mais
Present work examines and validates the novel numerical scheme to calculate the velocity, stress, strain, pressure and strain rate fields of metal plastic flow in direct extrusion processes by employing the finite volume method, FVM. Traditionally, the classical methods such as the upper-bound, slab, slip-line and more recently the Finite Element Method have been largely applied in metal extrusion analysis. However, recently the FVM has been applied and published by the authors for analysis of metal plastic flow, concluding that direct extrusion of metals could be mathematically modelled by the plastic flow formulation similar to an incompressible non-linear viscous fluid. Tannehill et al. suggested that viscous fluid flow can be numerically simulated by FVM, obeying the mass, momentum and energy conservation equations and boundary conditions. Hence, the governing equations of metal plastic flow in Euler approach were discretized by FVM, using the Explicit MacCormack Method in structured, fixed and collocated mesh. SIMPLE method was applied to attain the necessary pressure-velocity coupling. These new numerical scheme was applied to the analysis of direct hot extrusion process of Al 6351 and Al 6060 aluminium alloys. The velocity and other variables fields achieved fast convergence and a good agreement with experimental results from visioplasticity tests by the grid stripe pattern technique and Forge 2008 software. The MacCormack Method applied to metal extrusion revealed consistent results without the need of artificial viscosity as required by the compressible fluid flow simulation approaches. Therefore, present numerical results confirm that FVM with MacCormack method together with Euler formulation approach and SIMPLE method can be applied satisfactory in the solution of metal forming processes
Ver menos
CONSELHO NACIONAL DE DESENVOLVIMENTO CIENTÍFICO E TECNOLÓGICO - CNPQ
Fechado
Analysis of metal extrusion by the finite volume method
José D. Bressan, Marcelo Matos Martins, Sérgio Tonini Button
Analysis of metal extrusion by the finite volume method
José D. Bressan, Marcelo Matos Martins, Sérgio Tonini Button
Fontes
|
Procedia engineering Vol. 207 (2017), p. 425-430 |